Sewer Cleanout Work in Kent
HomeGuide describes a cleanout as a vertical pipe off the house sewer with a removable cap, the entry point for cleaning, inspection and repair tools.

Double Cleanouts Facing Both Directions
A two-way cleanout is two pipes set side by side at 45-degree angles, one facing the house and one facing the street. That gives access to both sides of the line, and HomeGuide calls it the most popular choice with homeowners. It's also the pricier one:
- HomeGuide: $2,000 to $5,000 installed, mostly labor
- Angi and HomeAdvisor: about $2,700
- Bob Vila: about $2,000
- Plumber labor: $75 to $150 an hour, per HomeGuide

One-Way Cleanouts Beside the Crawlspace Wall
A single cleanout is one pipe joined to the sewer at 45 degrees. HomeGuide notes it gives access in one direction only, toward the public connection, and prices it at $1,400 to $2,500 installed. Near the foundation it lets the plumber run the whole side sewer out to the street, but not back toward the house. For a home where clogs keep happening in the building drain, ask whether a two-way is worth the difference.

Tracking Down a Cleanout Lost Under Bark or Sod
HomeGuide describes the usual look: a white or black cap, 3 to 6 inches across, sitting flush with the ground or slightly above it, near the foundation or the property line. Before deciding there isn't one, check under bark mulch, sod and gravel in those spots. If the search turns up nothing, a camera run from inside the house can trace the line and find the right spot to dig. The sewer camera inspection page covers the camera and locating work.

Replacement Caps and Damaged Riser Tops
A cracked or missing cap leaves an opening into your sewer, so get it replaced rather than taped over. The part is cheap: HomeGuide puts a replacement cap at $5 to $50. When the riser pipe is broken too, it's a bigger job, and Fixr prices replacing a cleanout at $1,000 to $3,500.

Why Kent homeowners and businesses call Kent Hydro Jetting
- The request is free, and you decide whether to book
- One licensed local plumber gets your request, not a call list
- Ask for a camera look before any pressure goes in
- Ask for the price in writing before the work starts
- You pay nothing for the referral
Permits and Digging Rules in Kent
Two sets of rules apply once a shovel is involved:
Utility locate
Washington's dig law, RCW 19.122.030, says the excavator has to mark the dig area in white and notify the one-number locator service at least 2 and no more than 10 full business days before work begins. Ask who will file the locate request.Kent permit
a clog can be cleared without a Kent permit, but constructing, extending, relaying or repairing a side sewer needs one. Whether a new cleanout counts is a question for the plumber and the city's permit staff. See sewer line repair for the rule.
Kent Houses Without a Cleanout
HomeGuide says most homes built after 1970 include cleanouts because plumbing rules changed, and building codes in most areas now require them for new construction and major plumbing work. Older houses are the likeliest to lack one. Without one, HomeGuide notes, plumbers have to reach a main line clog through sinks, tubs or toilets, and pulling a toilet costs extra; our toilet clog clearing page has what that adds. How much of Kent's housing predates 1970 is on the sewer scope inspection page.
